Conveyor Belt Cleaning Tool w/ Suction, 500mm (20in)

$2,133.47

$2,133.47

In stock

Shopping Cart

No products in the cart.

Conveyor Belt Cleaning Tool w/ Suction, 500mm (20in)

$2,133.47

This tool mounts above conveyor belts and uses dry steam from the Optima Steamer™ to quickly clean and sanitize as the belts run. Steam is delivered in an enclosed compartment to aid in sanitation and eliminate overspray contamination, while waste matter is removed via port for vacuum hook-up. Cleaning compartment measures 500mm (20in) wide.

In stock

Temperature

Vapor steam reaches temperatures well above 212°F, water’s boiling point and what makes it a gas. Hot water from your pressure washer or plant steam from your in house boiler only creates diffused water particles or mist (wet steam), and the output is typically below 180°F

No Waste Water / Run-Off

Vapor steam is a gas and has far fewer water molecules, producing little to NO wastewater. Hot water and in-house boiler steam leads to runoff and requires drainage which is bad for cleaning and sanitation. Steam is ideal for dry facilities, plants without drains and facilities that are looking to evolve their sanitation methods to CIP and SIP.

Clean and Sanitize

Combination of vapor steam and vacuum achieves two tasks – cleans and sanitizes belt surface at the same time. High temperature and pressure from vapor steam not only break down grease or pollutants on the belt, but also remove microorganisms.

Required Steamer OPTIMA XE 27K, SEII 27K/42K
Required Steam Hose Power Steam Hose (P/N A70039, A70059, A70060)
Required Vacuum Hose Heat Resistant Vacuum Hose (P/N 85-50088)
Vacuum Hose Inlet Diameter (E) 1.5” (38mm)
Recommended Belt Closed surface type (flat belt)
Material Stainless steel, Silicone
Cleaning Width (A) 20” / 610mm
Mounting Width (B) 23.6-31.5” (600-800mm)
Adjustable Chamber Height (D) 5.9” (150mm)
Steam Vacuum Chamber Size 19.69×10.24×17.3” (500x260x225mm)
Dimensions (L x W x H) (mm) Part #85-50083:
35.4×10.2×17.3” (900x260x440mm)
Part #85-50131:
55.1×10.2×17.3” (1400x260x440mm)
Weight 26.5 (12 kg)

*Note: The Vacuum Conveyor Belt Cleaning Tool is recommended for closed belt types and is best used with 10m Power hose part # 70039. For open belts, we recommend the Pneumatic Conveyor Belt Cleaning Tool.

Weight 25 lbs
Dimensions 28 × 14 × 11 in
Country of Origin

Republic of Korea (South Korea)